LumaSense Technologies INNOVA 1412i - Manual (Page 36)

Chapter 4
______________________________________________________________________
_____________________________________________________________________________
BE6025-15 1412i Photoacoustic Gas Monitor LumaSense Technologies A/S
Page 36 of 202
4.3 Familiarization with the Monitor using the Front
Panel
4.3.1 Setting the Internal Clock
Before dispatched from the factory, the internal clock of the Monitor
is set to the correct local (Danish) time. If the monitor is to be used
as a stand-alone instrument, then the clock can be adjusted to your
local time using the following instructions.
1. Switch on the AC Mains power switch on the back-panel of the
Monitor.
2. Press SET-UP.
Refer to the Set-Up Tree, supplied with the Monitor, so that you can
follow your movement through the various branches of this “tree” in
the following sequence of button presses.
3. Press S3 S1 S1 S1