Rhino Shelter BARN-12W X 28L X 12H - Manual (Page 10)

Assembly Instructions Barn Style 12 x 28 x 12
acts as a cushion to avoid rubbing damage to the cover
over years.
Unpack the Main Cover #22 from the protective plastic
packaging. The line of grommets on the inside (white) of
the cover on the tie down Flap runs parallel to the sides
of the frame assembly for positioning. Once cover is
oriented properly to the Frame Assembly, pull Main
Cover over frame assembly from the side, being careful
not to snag the cover on any member, bolt, or other
obstruction. Center the Main Cover over the Frame
Assembly with the Main Cover colored side showing
from the outside of the unit.
Step 2. Secure the Main Cover Corners - Loosen the 4
remaining turnbuckles completely. Place the
turnbuckles into outer hole in the foot of each end arch.
Tie off the rope coming out of the Main Cover rope slot
on either side to the turnbuckles. After securing one end
of the rope in the Main Cover, pull the excess slack out
of the rope and cover to tighten. Hold the end of the
unsecured rope and apply pressure downward with a
foot to remove excess. Temporarily tie the end of the
rope to the turnbuckle.
Remove Slack From Cover Rope
Go over the entire outer edge of the cover rope packet
and adjust the excess material around the end so it is
not bunched up. Spread excess material evenly along
the outer edge. Once cover is pulled tight and even, tie
off the rope end to the turnbuckle. All slack should be
out of the rope at this time. Repeat this step on both
ends of the cover. Tighten the turnbuckle to tighten the
cover. This step may need to be repeated to ensure a
snug and centered fit.
Main Cover Turnbuckle secured to Base Foot
Step 3. Lace Cover To Base Cross Rails - When the
cover is completely aligned secure the cover to the
bottom tie-down cross rail using the rope provided. Start
at one end and tie off the rope to the cross rail. Lace the
rope through the grommets in the cover and back under
the tie-down cross rail. Repeat this on the opposite side
V1.2
Do NOT Return Assembly To Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
10