Rhino Shelter SHED-5WX10LX8H - Manual (Page 9)

Assembly Instructions
5x10x8 CycleCabana
TM
V1.0
Do NOT Return Assembly To Dealer or Store. For All Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
8
Loosen the 4 remaining turnbuckles completely. Place
the turnbuckles into outer hole in the foot of each end
arch. Tie off the rope coming out of the Main Cover rope
slot on either side to the turnbuckles. After securing one
end of the rope in the Main Cover, gently pull the excess
slack out of the rope and cover to tighten. Hold the end
of the unsecured rope and apply pressure downward
with a foot to remove excess. Temporarily tie the end of
the rope to the turnbuckle. Go over the entire outer
edge of the cover and adjust the excess material around
the end so it is not bunched up. Spread excess material
evenly along the outer edge. Once cover is pulled tight
and even, tie off the rope end to the turnbuckle. All slack
should be out of the rope at this time. Repeat this step
on both ends of the cover. Tighten the turnbuckle to
tighten the cover. This step may need to be repeated to
nsure a snug and centered fit.
Door Hold Ups
e
Wh
to
tart at one end and tie off the rope to the cross rail.
e
oppo
the
arou
Produ
stre
en the cover is completely aligned secure the cover
the bottom tie-down cross rail using the rope provided.
S
Lace the rope through the grommets in the cover and
back under the tie-down cross rail. Repeat this on th
site side
Pay close attention to how tight the cover is put onto
frame. It should be tight enough so it does not flap
nd in the wind, but not so tight that it tears the
material cover. The fabric backed PE fabric of MDM
cts units does not stretch. If you pull it so tight that
the fabric is stretched, a small amount of additional
ss from wind or contact can cause premature tears
and material failure. Only tighten cover enough to
remove valleys between arch assemblies. Do Not over
tighten.
Ret
nd end
anels. Retighten the rope holding the main cover to the
ighten the turnbuckles on both the cover a
p
bottom cross rail. Both the cover and the end panels
should be checked and tightened on a monthly
basis.
t on
our(4) bungee straps are provided to retain the door up.
h
All MDM Products doors are manufactured with a pocke
the bottom edge along the width axis. A ½” to 1” plastic or
metal tube can be inserted into the pocket and trimmed to
fit width. Weight will reduce door movement in wind.
F
Roll the door from the bottom and secure the door roll wit
a bungee through the upper door grommet as shown.