RIKON Power Tools 10-201 User Manual

Page 12

Advertising

RIVING KNIFE/SPLITTER COMPONENTS
ASSEMBLY

Note: Remove the table insert ( Table insert are gripped
by four magnets on the table).

Fig.21

INSTALLING AND REMOVING
THE RIVING KNIFE/SPLITTER

1. Loosen the knob (C),Line up the riving knife/splitter in

the proper direction to the mounting bracket (B).

2. Push the Riving Knife/

all the way down into the

mounting bracket, make sure the location pin is
properly locked in the hole of the Riving Knife/

(The location hole is on the button side of the Riving
Knife/

3. Tighten the fasting knob(C).

1. Loosen the fasten knob (C).

2. Remove the Riving Knife/

out of mounting

bracket.

Make sure blade or arbor is at the highest

position before adding or removing the riving
Knife/

SEE FIG22.

splitter

SEE FIG.23

NOTE:

•Remove

Fig.22

Fig.23

BLADE ASSEMBLY

Fig. 24

Advertising