RIKON Power Tools 10-201 - Manual (Page 39)

A T T E N T I O N
TSB 18
11.10
Miter Gauge Slot Adjustment
Align two holes located on the left/right extension wings
to the two pins on the cabinet.
After extensions wings are installed, screw in 5/16-18 Hex
Round Screws (4) to the extensions, but not too tight.
Locate the miter gauge in the T-slot on table top.
To measure the overall flateness, use a straight edge on
the table top. If the flateness is acceptable, no need to
make any adjustment. If it's not satisfacotry, use the
leveling screw of the table bottom and set screws to
adjust the flatness
1.
3.
2.
4.
If the slot between main table and extensions is too
narrow, please loosen two pins of the table bottom, and
fine-tune by moving the extension outwards slightly until
the slot have enoght space for miter gauge to move
smoothly, then you can tighten two pins back slightly 1.
If the slot between main table and extensions is too
wide, please loosen two pins of the table bottom, and
fine-tune by moving the extension forwards slightly until
the slot have enoght space for miter gauge to move
smoothly, then you can tighten two pins back slightly 2.
Extension Wing Assembly
The following procedure is to help you fine tune your table top, wings and miter slot.
When assembled correctly, your table top will be within .008-.010 and the miter slot will
be ¾” x 3/8”.