Star Water Systems HSPJ100 (Flint & Walling) User Manual

Portable lawn sprinkler and utility pump

background image


© 2011. All rights reserved.


This pump is designed to sprinkle lawns and small
gardens from lakes, ponds, or rivers, empty or fill
stock tanks, remove standing water from flooded
areas, transfer water or boost water pressure.
Flammable liquids such as gasoline, chemicals or
corrosive liquids should never be used with this pump.

Safety Guidelines

This manual contains information that is very
important to know and understand. This information
is provided for SAFETY and to PREVENT EQUIPMENT
PROBLEMS. To help recognize this information,
observe the following symbols.

Danger indicates an imminently

hazardous situation which, if not avoided, will result
in death or serious injury.

Warning indicates a potentially

hazardous situation which, if not avoided, could result
in death or serious injury.

Caution indicates a potentially

hazardous situation, which, if not avoided, may result
in minor or moderate injury.
NOTE: Indicates important information, that if not
followed, may cause damage to equipment.

General Safety Information

1. Read these rules and instructions carefully. Failure

to follow these instructions could cause serious
bodily injury and/or property damage.

This pump is non-submersible.

This product contains chemicals

known to the State of California to cause cancer and
birth defects or other reproductive harm.

Pump only clear water.

Do not pump flammable or explosive fluids

such as gasoline, fuel oil, kerosene, etc. Do

not use in a flammable and/or explosive

atmosphere. Personal injury and/or property damage

could result.

NOTE: This pump is not designed to handle salt water,
brine, laundry discharge or any other application
which may contain caustic chemicals and/or foreign
materials. Pump damage could occur if used in these
applications and will void warranty.

All wiring must be

performed by a qualified electrician. The

pump must be installed in compliance with

all local and national codes.

2. Connect this product to a grounded circuit

equipped with a ground fault circuit interruptor
(GFCI) device.

3. Before installing this product, have the electrical

circuit checked by an electrician to ensure proper


BE CERTAIN the pump power source

is disconnected before installing or
servicing pump.

5. Be sure the water source and piping are clear of

sand, dirt and scale. Debris will clog pump and
void warranty.

6. Failure to protect pump and piping from freezing

could cause severe damage and will void the

7. Do not run pump dry.


1. Locate pump as close as possible to the water

source, keeping the vertical distance from the
water to pump as small as possible. Place pump
on level support. Protect against flooding and
excessive moisture.

2. Long lengths of pipe or hose and use of many

fittings will reduce pump flow. Use the smallest
number of fittings and shortest possible length of
pipe or hose.

4. Connect inlet pipe or hose to pump. The inlet

connection is designed for 1” NPT thread. Rigid
pipe such as PVC will work fine for inlet and outlet
pipe. (Reminder: Minimize length of pipe and
number of fittings.) An adapter for garden hose is
included (see Figure 1).