Triton FT5000 PC-BASED ATM Installation Manual - Manual (Page 31)

31
1. Locate the control panel trim
included with the unit accessories.
On the back side are 4 clips (Figure
1a) that will align with 4 slots on
the sleeve control panel (Figure 1b).
2. Before mounting the trim, ensure
the speaker wires and LED light
cables are routed through the
opening above the control panel.
These will be connected later. Align
the trim clips with the sleeve slots
and insert until the trim is seated
on the control panel.
3. Once the trim is in place, open the
side panels on the cabinet sleeve
and secure the trim panel with 16
Phillips head screws included in the
accessory kit (4 on each side).
I
NSTALLING
C
ONTROL
P
ANEL
T
RIM
Figure 1a. Location of clips on con-
trol panel trim.
Figure 2a. Remove retaining screw
to open panel.
Figure 2b. Screw locations for secur-
ing bottom of trim .
S
ITE
P
REPARATION
/I
NSTALLATION
Note
2 screws holes are accessed inside
the small silver panel (Figure 2a).
Slide the dispensing mechanism
back approximately one (1) foot and
use a magnetic Phillips driver to hold
screws. Screw holes are located in
upper slots shown in Figure 2b.
Figure 1b. Location of slots on con-
trol panel.