Vapamore MR-100 Primo - Manual (Page 5)

handle safety latch.
FILLING & OPERATION
Fig. 7
Fig. 8
The red light will illuminate when the power button is
depressed indicating the unit is heating. The green light
will illuminate indicating the unit is fully heated and
ready for use (approximately 11 minutes). The green
light will cycle on and off with the heater to maintain full
temperature during use. (Fig.10)
Fig. 9
Fig. 10
Green
light
Red
light
Fig. 11
Fig. 11
!
er fill
NOTE:
Do not ov
!
!
!
!
Do not over fill
To fill the water tank, switch the steam cleaner off and remove the plug from the wall
outlet. Allow steam cleaner to cool down before removing water tank cap. Unscrew the
water tank cap (Fig.7) by pressing the cap down and simultaneously turning counter
clockwise. Use the supplied funnel and the measuring cup filled to the top line marked
700ml two (2) times to equal 1.4 liters of water. (Fig.8)
Replace the water tank cap by pressing down on the cap
and simultaneously turning it clockwise. Make sure the
cap is fully tight to prevent any steam from leaking out.
If steam leaks from the cap area turn the Vapamore off
and once cooled down tighten cap further.
Do not exceed the maximum of 1.4 liters
of water when filling the water tank. 1.4 liters is equal to
filling the measuring cup to the 700ml mark tow (2) times.
Plug the Vapamore into a proper wall outlet and switch
to the on position by pressing the on / off switch. (Fig.9)
Never aim steam directly at people,
animals, plants, or electrical systems. There is a risk of
scalding or electrical shock.
or
GO TO VAPAMORE.COM TO SEE THE MR-100 PRIMO INSTRUCTIONAL VIDEO