Video Mount Products FP-MFB - Manual (Page 3)

Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount
Step 2
Assemble the wall plate by attaching the top rail to the bottom
rail using the vertical supports and short M4 screws and
washers . You can identify the difference between the top and
bottom rail by the fact that the top rail is the one with the stopper
fl aps on either end.
Step 3
Mark the wall or desired mounting surface in preparation of instal-
lation of wall plate assembly ( , and ). If mounting to
wooden studs, pre drill pilot holes using a 7/32” drill bit. Attach the
wall plate assembly ( , and ) to the wooden stud using
the 5/16” by 2.5” long lag screw and washer making sure
the folded tabs on the wall plate assembly are towards the top.
WARNING: Please verify that your mounting surface will support the
combined weight of your mount, mounting hardware, and fl at panel.
Also verify that the mounting surface is safe to drill through. Please
note only mounting hardware for mounting to wooden studs will be
provided with the unit. If mounting to a surface other than wooden
studs then other hardware will be required. If in doubt or uncertain
about any of the above, please contact a professional installer.
Step 4
Determine the correct screw size and if you need to use washers,
lock washers, or spacers. Note: Spacers are used for TVs with re-
cessed hole patterns. Secure the TV to the mounting rails using
the appropriate hardware ( through ). Note: The brackets
have to be level with each other to work properly.
Step 5
Use the hooks in the mounting rails to hook on the top rail of
the wall plate assembly . Use security screws and the long
allen key to secure the TVs to the bottom rail and to secure
its horizontal position. Please verify that all nuts and screws are
securely tightened.
Step 2: Assembling the wall plate
Step 3: Mounting the wall plate
WARNING: The installer of these products must verify that the mount
surface, ceiling or wall, will safely support the combined weight of
all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
2
1
6 4
5
Step 4: Attaching the mounting
brackets to the fl at panel
(spacers not needed)
Step 4: Attaching the mounting
brackets to the fl at panel (spacers
used due to recessed hole patterns)
Step 5: Securing the mounting
brackets to the wall plate
2 1 4
9
3
23
1
3
8
7
2
25 26
2 1 4