Video Mount Products LCD-CM2B User Manual
Page 3
Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before at-
tempting to assemble the mount. Note: The LCD-CM2B and LCD-1CB
combo was designed to mount two of the same TV or TVs of similar
size and weight. It is not designed to have two signifi cantly different
TVs mounted. Note: LCD-1CB part numbers have circles around their
numbers and LCD-CM2B has hexagons around their part numbers.
Step 2
Mark the ceiling or desired mounting surface in preparation of instal-
lation of ceiling plate (
#1
LCD-1CB). If mounting to wooden ceiling
joists, pre drill pilot holes using a 7/32” drill bit. Attach the ceiling plate
(
LCD-1CB) to the wooden ceiling joist using the 5/16” by 2.5” long
lag screw (
#23
LCD-1CB) and washer ( LCD-1CB). WARNING:
Please verify that your mounting surface will support the combined
weight of your mount, mounting hardware, and fl at panel. Also ver-
ify that the mounting surface is safe to drill through. Please note only
mounting hardware for mounting to wooden ceiling joists will be pro-
vided with the unit. If mounting to a surface other than wooden ceil-
ing joists then other hardware will be required. If in doubt or uncertain
about any of the above, please contact a professional installer.
Step 3
Insert end plugs (
#14
LCD-1CB) into the support tube (
# 1
LCD-CM2B).
Attach the pivot brackets (
#2
LCD-CM2B and
#4
LCD-1CB) to the
support tube (
# 1
LCD-CM2B) using washers (
#1 0
LCD-CM2B and
#15
LCD-1CB) between the support tube (
#1
LCD-CM2B) and the pivot
brackets (
#2
LCD-CM2B and
#4
LCD-1CB) and two inch hex screw
(
#11
LCD-CM2B and
#16
LCD-1CB) and nylon nut (
#6
LCD-CM2B
and
#8
LCD-1CB). Thread the adjusting screws (
#12
LCD-1CB and
#8
LCD-CM2B) into the threaded hole in the bottom of the pivot
brackets
(#2
LCD-CM2B and
#4
LCD-1CB) until the bottom of the
screw is roughly even with the front of the pivot bracket.
Step 4
Attach the extension tube (
#2
LCD-1CB) to the support tube (
#1
LCD-
CM2B) using the large washers
(#11
LCD-1CB) and M12 Screw (
#10
LCD-1CB). Make sure the M12 screw (
#10
LCD-1CB) is tight and once
it is tight secure the screw in place by tightening the brake screw (
#17
LCD-1CB) in the threaded hole in the side of the extension tube (
#2
LCD-1CB). Make sure the brake screw (
#17
LCD-1CB) is as tight as
possible against the M12 screw (
#10
LCD-1CB) to properly secure that
screw.
Step 2: Mounting the ceiling plate
Step 3: Attaching the pivot
bracket to the support tube
Step 4: Attaching the extension
tube to the support tube
14
1
23
1
24
10
1
2
4
1
15
1
2
4
11
16
6
8
12
8
4
2
2
1
11
10
10
2
17
17
10