Video Mount Products LCD-MID-CHB User Manual
Page 3
Step 1
Before starting, lay out all parts to your mount and match them to
the parts list provided. Verify that you have all your parts before
attempting to assemble the mount.
Step 2
Attach the base plate
(#1)
to the pipe couple
(#3)
using the large
washers
(#9)
, PVC washers
(#10)
and M16 nylon nut
(#11)
. Once
the nylon nut
(#11)
is tight, slide the cotter pin
(#12)
through the
small hole near the bottom of the screw coming out of the pipe
couple
(#3)
. Note: Be sure to tighten down the nylon nut
(#11)
as
far as possible to prevent sag or list in the mount.
Step 3
Attach the tilt plate
(#2)
to the base plate
(#1)
by first inserting
plastic washers
(#8)
in between the base plate and tilt plate on
each side. Then insert the 5/16” by ¾” long square neck screws
(#7)
into the base plate
(#1)
so the screws are pointed outwards.
On the bottom screws on each side secure the screws with the 19
mm outer diameter washers
(#14)
and nylon nuts
(#18)
. On the
upper screws place the 25 mm outer diameter washers
(#13)
and
use the gear nuts
(#15)
, lever handle
(#16)
and lever screw
(#17)
to secure the tilt plate’s
(#2)
position. Tilt the tilt plate
(#2)
as far up
as it will go and lock the tilt into place by tightening down the lever
handle
(#16)
as far as it will go on each side. Note: This is important
to do to allow step 9 to be accomplished safely and easily.
Step 4
Determine the correct screw size and if you need to use washers,
lock washers, or spacers. Note: Spacers are used for TVs with re-
cessed hole patterns. Secure the display to the screen mounting
brackets
(#4)
using the appropriate hardware
(#21
through
#35)
.
Note: The brackets have to be level with each other to work properly.
Step 2: Attaching the base
plate to the pipe couple
Step 3: Attaching the tilt plate to
the base plate
1
1
2
Step 4A: Attaching the flat panel to
he screen mounting brackets
(spacers not needed)
3
1
3
9
8
7
Step 4B: Attaching the flat panel to the
screen mounting brackets
(spacers used for recessed hole pattern)
10
11
11
11
14
18
13
15
16
2
2
16
4
21
35
12
17