Video Mount Products LCD-MID-FTB - Manual (Page 4)

Step 4: Adjusting the tilt tension
before placing the screen on
the wall
Step 4
Adjust the tilt tension by tightening the socket head screws with
the M5 Allen Key so they are fairly tight. Note: You may have
to adjust the tilt tension once the fl at screen is on the wall so do not
tighten as hard as you can because it will make further adjustment
on the wall much more diffi cult.
Step 5
Use the hooks on the pivot bracket to hook on the top rail of the
wall plate . Use the M5 screws to secure the TV to the wall
plate and to secure its horizontal position.
Step 6
If you need to adjust the tilt tension:
Tilt down the fl at screen as far as it will go. Note: This is done to give
you room to work with behind the fl at screen. Take the M5 Allen Key
and tighten down the socket screws until you have
achieved the desired tilt tension and readjust the tilt to the desired
angle.
Please verify that all nuts and screws are securely tightened.
Step 5: Securing the pivot
brackets to the wall plate
Step 6: Adjusting the tilt tension
after placing the screen
on the wall
WARNING: The installer of these products must verify that the mount-
ing surface, ceiling or wall, will safely support the combined weight
of all attached equipment and hardware. Video Mount Products will
not be held liable for the improper use or installation of its products.
Enjoy Your Mount!
4
9
1
2
1
10
4 10
VIDEO MOUNT PRODUCTS