Vitrex MULTITOOL - Manual (Page 4)

Multi-Tool www.vitrex.co.uk Tel: +44 (0)1253 789180
4）Use and maintenance of power tools:
a. Do not force the power tool. Use the correct power tool suitable for your application. The correct power
tool will do the job better and safer at the rate for which it was designed.
b. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c. Disconnect the plug from the power source and/or battery pack from the power tool before making any
adjustments, changing accessories, or storing the power tool. Such preventative safety measures reduce the
risk of starting the power tool accidentally.
d. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool
or these instructions to operate the tool.
Power tools are dangerous in the hands of untrained users.
e. Maintaining power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condition that may affect the power tool’s operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f. Tools with sharp points are more likely to injure. Always remove the attachment when done working with
the power tool. Never store a power tool with an attachment still attached to the tool.
g. Use the power tool, accessories, etc. in accordance with these instructions, taking into account the working
conditions and the work to be performed. Use of the power tool for operations different from those
intended could result in a dangerous situation.
5) Service:
a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.
Always check if your mains voltage corresponds with the value on the type plate.
The machine has been double-insulated in accordance with EN60745: therefore, an earth wire
is not necessary.
Use correct supply voltage:
The power supply voltage must match the information quoted on the tools identification plate.
Use proper extension cord:
Only use an approved extension cable that is suitable for the machine's power. The conductors of the cord must
have an area of at least 0.75 mm
2 . When the extension cable is on a reel, unroll the cable in its entirety.
Switch off the machine immediately in case of:
a. Malfunction in the mains plug, power cable or damaging of cable.
b. Broken switch.
c. Smoke or smell of scorched insulation.