WEN 3500 Generator Air Cleaner and Carburetor Removal User Manual
Page 4
Advertising
There is an air duct that goes from the Air Cleaner to the OHV cover on the engine. Remove
this air duct from the Air Cleaner by pulling up on it. It is a friction fit. There are no clamps.
Remove the Air Cleaner to expose the carburetor.
Note there is a gasket BETWEEN the Air Cleaner and the Carburetor.
Set the gasket aside for reassembly later on.
If you are removing the Carburetor, disconnect the fuel hose by releasing the hose clamp and
sliding it back on the hose. (NOTE: Be sure the fuel valve is turned to the OFF position under
the gas tank.) Remove the hose by pulling it away from the carburetor.
Advertising