WycoTool Sure Speed electric vibrator - Manual (Page 6)

Flex Shaft Concrete Vibrator
Page 6 June 2014
Emissions
1 Declared noise emission values:
K = 0 69 dB
L
pA
= 83 1 dB
L
WA
= 94 1 dB
OTEE: N Wear hearing protection
2 Declared vibrator emissions:
Front Handle = 4 28 m/s 2
K = 1 50 m/s 2
Rear Handle = 2 41 m/s 2
K = 1 50 m/s 2
OTEE: N The declared vibration total value has been
measured in accordance with a standard test
method and may be used for comparing one tool
with another The declared vibration total value may
also be used in a primary assessment of exposure
WARNING
THE VIBRATION EMISSION DURING ACTUAL USE OF THE
POWER TOOL CAN DIFFER FROM THE DECLARED TOTAL
VALUE DEPENDING ON THE WAYS IN WHICH THE TOOL IS
USED.
SAFETY SYMBOL EXPLANATIONS
Volts
Amperes
Hertz
Alternating Current
Class II Tool
IP Symbol
Ground Terminal (Protective Earthing)
ON
OFF
Refer to Instruction Manual
Variability in Steps
V
A
Hz
IPX4
Figure 1: Safety symbols
Additional Safety Note
Double insulated tools are equipped with a polarized plug
(one blade is wider than the other) This plug will fit in a
polarized outlet only one way If the plug does not fit fully
in the outlet, reverse the plug If it still does not fit, contact
a qualified electrician to install a polarized outlet Do not
change the plug in any way Double insulation eliminates the
need for the three-wire grounded power cord and grounded
power supply system
INTRODUCTION
This concrete vibrator motor is used to power concrete flex
shaft vibrators which provide vibration to consolidate freshly
poured concrete The vibration is created by an eccentric (off
center) weight within the vibrator head As the weight spins
it forces the head housing to move within the fresh concrete
The continuous head movement agitates the concrete
mixture resulting in significantly reduced voids
This motor can be used with any valid Wyco vibrator
head and shaft combination See Table 1: Head and shaft
combinations on page 6 or common combinations Shafts
are available in lengths of 2, 5, 7, 10, 14, 20 and 30 feet (0 61,
1 52, 2 13, 3 05, 4 27, 6 1, and 9 14 m)
WARNING
DO NOT USE NON-APPROVED PARTS. THE USE OF NON-
APPROVED PARTS MAY CAUSE A HAZARDOUS CONDITION
FOR THE OPERATOR.
Vibrator Head Vibrator Shaft
Size in.
(mm)
Model No Length CK Series
13/16 (4 76) 750-D 2 20 ft
(0 61 6 1m)
8900
1 (25 4) 750-EH
1-3/8
(34 92)
750-FI
2 20 ft
(0 61 6 1m)
9500
1-3/4
(44 45)
750-GI
2 (50 8) 750-LI
2-1/4
(57 15)
750-MI
2-1/2 (63 5) 750-SBI
1-3/8
(34 92)
750-FI
30 ft
(9 14 m)
Table 1: Head and shaft combinations