Catskill Craftsmen 1426 - Manual (Page 10)

ASSEMBLE DRAWERS
A. Attach the Drawer Back to the Left
and Right Drawer Sides with four 1 ¼”
#8 Screws. Make sure the slots that run
the length of the Sides are aligned with
the slot in the Drawer Back to accept the
Drawer Bottom.
B. Slide in Drawer Bottom, best side up,
C. Take two (2) Bastion Posts for the top
drawer, four (4) Bastion Posts for the
bottom drawers, align the threaded ends
of the Posts with the post holes located
near the ends of the inside Drawer
Front. Tighten Posts down until the
solid shaft of the Post hits the wood.
Back Post out until the hole/screwdriver
slot in the end of the Post is parallel and
in direct line with the long edges of the
Drawer Front.
D. Insert the Bastion Nuts (B-Nuts) into
the nut access holes on the inside of the
Drawer Sides with the threaded end
facing out. Take the Drawer Front and
carefully insert the Posts into the ends of
the Brace Sides, through the sides of the
B-Nut until seated. Push Nut snugly
against the wood in the nut access hole
toward the Drawer Front. Hole should be
slightly off-center toward the Drawer
Front. Insert the Set Screw and tighten
down. The Drawer Sides should be tight
against the Drawer Front.
E. Attach the Drawer Handle with 8-32
Truss-Head screws.
Attach the Drawer Glides (left and Right)
to the Drawer Sides using two 5/8” #5
Flat Head Screws per glide. Wheels go
toward Drawer Back and are up. DO
NOT INSERT DRAWERS INTO
CABINET AT THIS TIME.
Illustration 7A
Illustration 7B
Illustration 7C
Top Drawer Front
Illustration 7E
Illustration 7F
Illustration 7D
Bottom Drawer Fronts
7