Catskill Craftsmen 1448 - Manual (Page 11)

Illustration 8C
Drawer Front
D. Insert the
B-Nuts into the nut
access holes on the inside of
the Drawer Sides with the threaded
end facing out. Take the Drawer Front and
carefully insert the Posts into the ends of the
Brace Sides, through the sides of the B-Nut until
seated. Push Nut snugly against the wood in
the nut access hole toward the Drawer Front.
Hole should be slightly off-center toward the
Drawer Front. Insert the Set Screw and tighten
down. The Drawer Sides should be tight against
the Drawer Front.
Illustration 8D
C. Take two (2) Bastion Posts, align the threaded
ends of the Posts with the post holes located near the
ends of the inside Drawer Front. Tighten Posts
down until the solid shaft of the Post hits the wood.
Back Post out until the hole/screwdriver slot in the
end of the Post is parallel and in direct line with the
long edges of the Drawer Front.
E. Attach the Drawer Glides (left and
Right) to the Drawer Sides using two
7/16” #6 Pan Head Screws per glide.
Open end of glide goes toward the back
of the drawer.
DO NOT INSERT DRAWER
INTO CABINET AT THIS TIME.
Illustration 8E
10