Catskill Craftsmen 1531 - Manual (Page 11)

STEP 15
1 1/4” Phillips Flat Head #8 Screw (27)
2 Used in this step
STEP 14
A. Attach the Back Splash to the back edge of the Table
Top with 1 1/4” #8 Screws in three places as shown.
Next, start one 1 1/4” #8 Screw through each upper
hole in Back Splash into pilot holes on short flat edge
of the BS-6 Side Splashes.Then take the 1 1/4”
Screws, come up through the bottom of the Table Top, align the Scre
BS-6, and when all screws are aligned in their
respective pilot holes, tighten down.
ILLUSTRATION 16
1 1/4” Phillips Flat Head #8 Screw (27)
7 Used in this step
3/16” Flat Washer (6)
2 used in
this step
A. Determine if you want the Towel Bar on the left or right Side Panel. The Knife Rack will go on the
other. Then attach the Towel Bar to the Side Panel with two 1 1/4” x #8 screws from inside the panel.
Place a washer over the screw so that so that the head won’t pull through
the side panel.
TB
S2
S2
S1
P1