Catskill Craftsmen 1531 - Manual (Page 5)

STEP 3
A. Attach the drawer back to the drawer sides with
four 1 1/4” #8 screws. Make sure parts are aligned
as in illustration 3A.
B. Insert drawer bottom into the slots in the drawer
sides, best side to inside of drawer. Slide down
until seated in the slot in the drawer back.
See illustration 3B.
C. Screw the cam posts into the two outside holes
on the inside face of the drawer front until seated.
Only 3/8” of this post goes into the wood, leaving
the 4 guide rings/head exposed. See illustration 3C.
D. Insert the posts into holes in the drawer side
until seated against the front ends of the drawer
sides. Insert cams so that slot in the cam fits over
the post and turn with Phillips screwdriver until
seated. Don’t over-torque! See illustration 3D.
E. Attach drawer handle with the two 3/4” Truss
Head Machine screws ( no illustration ).
ILLUSTRATION 3A
Below line in wood
Cam Posts (2)
ILLUSTRATION 3C
ILLUSTRATION 3B
ILLUSTRATION 3D Cam (2)
2 used
in this step
3/4” Truss Head Machine Screw (2)
2 used
in this step
1 1/4” Phillips Flat Head #8 Screw (27)
4 used
in this step
D1
D1
D2
D2
D2
D4
D4
D4 D3
D3
D3
D5
D5