Catskill Craftsmen 51536 - Manual (Page 10)

STEP 11
A. Insert and tap caster sockets with
hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT OR
CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing
straight downward with heel or your hand,
or tap into place with a hammer. Don’t
be afraid to give them a good downward
whack on the solid metal part of the caster!
C. Locking wheels usually go on front.
ILLUSTRATION 11
STEP 12
A. Upright unit. Take bottom shelf (no edge
banding) and place it on the set of back
pins. Close doors and shelf will drop into
place.
B. Decide on position of middle
shelf, then tap two 1” pins into
each side panel, making sure the
pins on both sides are in the same
relative position. To remove a pin,
use pliers or claw hammer.
C. Place middle shelf, edge banding
out, on pins.
D. Insert drawer.
Note: If the top edge of the drawer
front hits the underside of the cart
top or the top edge of the top front
brace, loosen the machine screws in
the top front brace a little and adjust
brace down until drawer opens/closes
freely - check to make sure doors
open/close freely. Re-tighten all bolts!
E. Tap wooden disks into sides.
ILLUSTRATION 12
Edge
Banding