Step 1 – Catskill Craftsmen 72265 User Manual

Page 4

Advertising
background image

Step 1

Assemble Drawer

A. Attach the Drawer Back to the Left
and Right Drawer Sides with four 1 ¼”
(32mm) #8 Screws. Make sure the slots
that run the length of the Sides are
aligned with the slot in the Drawer Back
to accept the Drawer Bottom.

B. Slide in Drawer Bottom, best side up,

C. Take two (2) Bastion Posts, align the
threaded ends of the Posts with the post
holes located near the ends of the inside
Drawer Front. Tighten Posts down until
the solid shaft of the Post hits the wood.
Back Post out until the hole/screwdriver
slot in the end of the Post is parallel and
in direct line with the long edges of the
Drawer Front.

D. Insert the B-Nuts into the nut access
holes on the inside of the Drawer Sides
with the threaded end facing out. Take
the Drawer Front and carefully insert the
Posts into the ends of the Brace Sides,
through the sides of the B-Nut until
seated. Push Nut snugly against the
wood in the nut access hole toward the
Drawer Front. Hole should be slightly
off-center toward the Drawer Front.
Insert the Set Screw and tighten down.
The Drawer Sides should be tight
against the Drawer Front.

E. Attach the Drawer Handle with M5/25
Truss-Head screws.

Attach the Drawer Glides (left and Right)
to the Drawer Sides using two 5/8”#6
Flat Head Screws per glide. Wheels go
toward Drawer Back and are up.

Illustration 1-A

Illustration 1-B

Illustration 1-C

Drawer Front

Illustration 1-E

Illustration 1-F

Advertising