Catskill Craftsmen 72265 - Manual (Page 6)

Step 3
Attach Front and Back Braces
A. Tap 3/4” (19mm) steel pins into front
and back braces. Align pins with pilot
holes on side panels.
B. Using 1-3/4” (44mm) Phillips flat
head bolt and hex nut, attach the top
and bottom back braces. Insert the nut
into the large hole, aligning it with the
bolt as shown in illustration 3-B. Hold
the nut in place with your finger while
tightening the bolt.
C. Using 1-3/4” (44mm) Phillips flat
head bolt and hex nut, attach the top
and bottom front braces.
Illustration 3-A
Illustration 3-B