Step 9, Step 10 – Catskill Craftsmen 54230 User Manual

Page 10

Advertising
background image

No pilot holes as softwood.

5/8” Pan Head Screws

STEP 9

A. Stick magnet to magnet plate on a door.
B. With all other doors open, close the door.

The magnet should be positioned over the

wooden block on the bottom of the top front

brace. Hold the magnet in place with your

thumb, and open the door. The magnet will

be in the correct position on the block.
C. Secure magnet with the two round head

screws in the magnet packet. Center screws

in the slot in the magnet. This will allow

adjustment later, if needed.
D. Repeat these steps for all the doors.

STEP 10

A. Insert and tap caster sockets

with hammer until the teeth grab

the wood. DON’T POUND SOCKET

FLAT OR CASTER SHAFT WILL

NOT ENTER.
B. Insert casters and seat by

pushing straight downward with

heel of your hand, or tap into place

with a hammer. Don’t be afraid to

give them a good downward whack

on the solid metal part of the caster!
C. Locking wheels usually go on

front.

Advertising