Step 5 – Catskill Craftsmen 54230 User Manual
Page 7
STEP 5
A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The
countersunk holes (reamed out) in the stick are positioned as in illustration so that the glide holes are
toward the lower edge. Sticks should be flush with top of panel.
B. Attach the cabinet glide of the Drawer Glides to the Glide Support Stick using 5/8” #7 flat head
screws. Left glide to left Side Panel, right glide to right Side Panel. The glides look almost alike
however, the right glide (as you face the cart) has a rolled lip at the top of the glide that keeps the
drawer glide wheel in place. Line up the holes in the glides so that the end with the wheel comes flush
with the front edge of the Table Top Stick.
C. Attach the “L” brackets to the top of the glide supports using 5/8” #7 screws. Use hole rather than
slot.
Note: Glides are marked right/left with imprint behind wheel.
TOP
TOP
5/8” #7 Screw
1 1/4” #8 Screw
5/8” #7 Screw