Catskill Craftsmen 53017 - Manual (Page 7)

3/4” Pin
Top Front Brace
Insert
STEP 5
Take the 2 front braces and tap/insert one 3/4”
steel pin into each end of both braces until
seated. About 3/8” will stick out when seated.
Ok if loose.
B. Insert two 3/4” pins in bottom brace as shown.
4 used in this step
3/4” Long 3/16” DIA. Steel Pin
STEP 6
A. Take the top front brace (with magnet block), insert the pins in the brace ends into the slots of the
inside of the front legs and slide down until the holes in the brace ends align with the holes in the front
legs as in illustration 6. The pin holes for the door pins will be up as will the magnet block.
B. Secure brace with 1 3/4” bolts and hex nuts.
1 1/4” #8 Bolts
Insert Brace Pins Here
Glide Suport
Assembly
2 used in
this step
1 3/4” Phillips Flat Head Bolt
2 used
in this step
10-24 Hex Nut
ILLUSTRATION 6
Bottom Front Brace