Catskill Craftsmen 51842 - Manual (Page 5)

7/8” Truss Head Screw
1/2” #4 Flat Head Screw
5/8” #8
1” Pin
3/4” Pin
The counter sunk hole
goes out so the bumps
go toward the wood.
1 1/2” Pin
Flush at bottom, space at top to clear magnet
Not used Not used
(Included in magnet pack)
Top Front Brace
Insert
STEP 1
A. Tap/insert ONE 1 1/2” pin into each end of all the doors. DON’T OVERDRIVE PINS! Pins should
stick up about 1/2” when seated.
STEP 3
Assemble Spice Rack
Insert retainer
rods into holes
Fasten Shelves with
1 1/4” Phillips Flat Head
#8 Screw (Bronze)
Pilot holes in shelves
go toward back
B. Attach the magnet
plate (may be stuck to
magnet!) with the 1/2” #4
screw to the top of the
doors. Bumps go toward
the wood.
C. Attach door handles
with 7/8” truss head
machine screws.
D. Attach door spacer
with three 5/8” Phillips
Head #8 screws.
STEP 2
A. Take the 2 front braces and tap/insert one 3/4” steel pin into each end of both braces until seated.
About 3/8” will stick out when seated. OK if loose.
B. Insert two 1” pins in bottom brace as shown.
7/8” Truss Head Screw
1/2” #4 Flat Head Screw
5/8” #8
1” Pin
3/4” Pin
The counter sunk hole
goes out so the bumps
go toward the wood.
1 1/2” Pin
Flush at bottom, space at top to clear magnet
Not used Not used
(Included in magnet pack)
Top Front Brace
Insert
Bottom Front Brace