Catskill Craftsmen 51842 - Manual (Page 8)

STEP 5
A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The
countersunk holes (reamed out) in the stick are positioned as in illustration 1 so that the glide holes
are toward the lower edge. Sticks should be flush with top of panel.
B. Attach the cabinet glide of the Drawer Glides to the Glide Support Stick using 5/8” #7 flat head
screws. Left glide to left Side Panel, right glide to right Side Panel. The glides look almost alike
however, the right glide (as you face the cart) has a rolled lip at the top of the glide that keeps the
drawer glide wheel in place. Line up the holes in the glides so that the end with the wheel comes flush
with the front edge of the Table Top Stick. Only 2 holes in the glide support are used.
C. Attach the “L” brackets to the top of the glide supports using 5/8” #7 screws. Use the large slot
rather than the hole/slot side. The hole will be used to attach the table top. The “L” Brackets should
be flush with the top of the glide support sticks.
Note: Glides are marked right/left with imprint behind wheel.
TOP TOP
5/8” #7 Screw
1 1/4” #8 Screw
5/8” #7 Screw