Catskill Craftsmen 51576 - Manual (Page 5)

STEP 2
Note: The side panels are interchangeable at this point. Drawer glides will determine left or right
sides. Choose at this point if you want the towel bar/handle on the left or right panel. We are using the
left side for these instructions. Cover photo shows towel bar/handle on right side.
A. Attach a Glide Support Stick to the top of each Side Panel using 1 1/4” #8 screws. The Sticks
should be flush with top of panel.
B. Attach the cabinet glide of the Drawer Glides to the Glide Support Stick using 5/8” #7 flat head
screws. Left glide to left Side Panel, right glide to right Side Panel. The glides look almost alike
however, the right glide (as you face the cart) has a rolled lip at the top of the glide that keeps the
drawer glide wheel in place. Line up the holes in the glides so that the end with the wheel comes flush
with the front edge of the Glide Support Stick.
C. Attach the “L” brackets to the top of the glide supports using 5/8” #7 screws. Use the long slot
rather than hole/slot. The hole will be used to attach the table top. The “L” brackets should be flush
with the top of the glide support sticks.
Note: Cabinet drawer glides usually have an imprint “CL” or “CR” inside near the wheel.
CR=Right / CL=Left
TOP TOP
5/8” #7 Screw
1 1/4” #8 Screw
5/8” #7 Screw
LEFT SIDE
RIGHT SIDE