Delmhorst Instrument J-2000 - Manual (Page 9)

INFORMATION ABOUT
YOUR READINGS
Readings below 6% will be displayed as a numeric value,
(-##.#), and will not be added to accumulation. A reading
below 6% which is due to temperature and species adjustments
will be shown as a numeric value with no minus sign and this
reading will be added to the accumulation.
Readings above 40% are always displayed as 999 and are
not added to the accumulation.
The meter will accumulate up to 100 readings. After all 100
readings are stored it will not add new readings until the
memory has been cleared. It will also continue to display
the average of all 100 readings as a reminder that the mem-
ory is full.
When taking and storing readings for a specific wood
species, be sure to “clear” the meter before moving on to the
next species if you do not want to group all of the readings
together.
TO CHECK ACCUMULATED
READINGS
This feature allows you to view the total number of all
accumulated readings, the average of those readings, and the
highest stored reading.
hTo view the readings press and release the calibration
check button
@
. First the meter displays the number of
accumulated readings for one second, then the average of
those readings for two seconds. Then it displays the highest
stored reading for two seconds. The total “cycle” time is
five seconds.
hTo erase readings hold the calibration check button
@
down for 5 seconds. All accumulated readings will be
erased and the meter will display “0”.
TO RESET METER
hPress and release the calibration check button
@
.
hWithin one second press the species button
#
.
hThe meter will reset itself and display “170” to indicated
Species #1 (Douglas Fir) at 70ºF. All of the readings in
memory will be cleared.
8