Accton Technology VM2548 - Manual (Page 32)

Installing the VDSL Switch and Splitter
3-2
Package Contents
VDSL Switch-VS2512A
• VDSL Switch-VS2512A
• Four adhesive foot pads
• Bracket Mounting Kit containing two brackets and four screws for attaching the
brackets to the switch
• One Power Cord—either US, Continental Europe or UK
• RS-232 console cable
• One FireWire Stack Cable
• This Installation Guide
• Management Guide
VDSL Splitter-VM2524/2548
• VDSL Splitter-VM2524 or VDSL Splitter-VM2548
• Four adhesive foot pads
• Bracket Mounting Kit containing two brackets and four screws for attaching the
brackets to the splitter
• This Installation Guide
Please complete the warranty registration card and return to Accton, or register
online at: register.acctontech.com.
Please inform your dealer if there are any incorrect, missing or damaged parts. If
possible, retain the carton, including the original packing materials. Use them again
to repack the product in case there is a need to return it for repair.
Optional Rack-Mounting Equipment
If you plan to rack-mount the switch and splitter, be sure to have the following
equipment available:
• Four mounting screws for each device you plan to install in a rack—these are not
included
• A screwdriver (Phillips or flathead, depending on the type of screws used)
Mounting
The switch and splitter may be mounted on any flat surface, such as a shelf, or in a
rack.
Before you start installing the switch and splitter, make sure you can provide the
right operating environment, including power requirements, sufficient physical
space, and proximity to other network devices that are to be connected. Verify the
following installation requirements: