GW Instek PSW-Series Programming & Command manual - Manual (Page 114)

PSW Series Programming Manual
114
A
PPENDIX
PSW Default Settings
The following default settings are the factory configuration settings
for the power supply (Function settings/Test settings).
Initial Settings Default Setting
Output Off
LOCK 0 (Disabled)
Voltage 0V
Current 0A
OVP Maximum
OCP Maximum
Normal Function
Settings
Setting Default Setting
Output ON delay time F-01 0.00s
Output OFF delay time F-02 0.00s
V-I mode slew rate select F-03 0 = CV high speed priority
Rising voltage slew rate F-04 60.00V/s (PSW 30-XX)
160.0V/s (PSW 80-XX)
320.0V/s (PSW 160-XX)
500.0V/s (PSW 250-XX)
1600V/s (PSW 800-XX)
Falling voltage slew rate F-05 60.00V/s (PSW 30-XX)
160.0V/s (PSW 80-XX)
320.0V/s (PSW 160-XX)
500.0V/s (PSW 250-XX)
1600V/s (PSW 800-XX)