GW Instek GDM-8261A User manual - Manual (Page 134)

GDM-8261A User Manual
134
4. Press the Down or UP keys
repeatedly to select the baud rate.
2304001152005760038400192009600
5. Press the Enter key followed by
the Exit key. The RS-232 setting
is stored and the display goes
back to the default display.
AUTO
ENTER
/ EXIT SHIFT
6. Connect the RS-232C cable to
the rear panel terminal.
RS-232C pin
assignment Pin 2: RxD
Pin 3: TxD
Pin 5: GND
Pin 1, 4, 6 ~ 9: No Connection
5 4 3 2 1
9 8 7 6
PC – GDM
RS-232C
Connection A null-modem connection, in which transmit (TxD) and
receive (RxD) lines are cross-linked, is required.
GDM PC
TxD
RxD
GND
Pin2
Pin3
Pin5
TxD
RxD
GND
Pin2
Pin3
Pin5
Set the EOL Character
Description The TX TERM configuration menu can set the
end-of-line (EOL) character for return messages. The
GPIB and LAN’s EOL character is fixed as CR+LF.
NOTE
The EOL character that is sent from the PC to the DMM
can be either CR, LF or CR+LF. The most common
EOL character is CR+LF.
EOL CR, LF, CR+LF (default = CR+LF)