In-Situ Telemetry System: Cube 300S Quick Start Guide User Manual
Cube 300s telemetry system, Connecting the cube to the computer, Select connected probes
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 1 Connecting an In-Situ Instrument to the Computer
- 2 Instrument Communication Settings
- 3 Connecting the Cube to the Computer
- 4 Select Connected Probes
- 5 Select Probe Parameters
- 6 Set the Site Name and Clock
- 7 Configure Options
- 8 Modem Parameters
- 9 Activate Alarms
- 10 Set Probe Reading Schedule
- 11 Set Wake Up Events
- 12 Activate the Modem
- 13 Test Remote Communications
- 14 Start the Cube
- 15 Deploy the Cube
- 16 Improving Signal Quality