In-Situ Rugged TROLL 200 Cable Suspension Kit User Manual
Page 2
For more information, contact In-Situ Inc.
221 East Lincoln Avenue, Fort Collins, CO 80524
1-800-446-7488 (toll-free in U.S. & Canada)
1-970-498-1500 (international & domestic)
www.in-situ.com
In-Situ and the In-Situ Inc. logo, Baro Merge, BaroTROLL, HERMIT, RDO, RuggedCable, RuggedReader, TROLL, and Win-Situ are trademarks or registered trademarks of In-Situ Inc.,
Fort Collins, CO, USA. Copyright © 2010 by In-Situ Inc. All rights reserved.
0080882 rev. 002 06/10
Place the third zip tie about 1 in (2.5 cm) below the first two ties. Place the fourth zip tie
5.
snug against the third.
Hand-tighten the zip ties. Do not overtighten.
6.
Note: You may also use the McMaster-Carr zip tie tool (# 7139K75) to tighten (and clip) the zip ties.
However, make sure not to cut through the cable by overtightening the zip ties.
Clip the excess tie material from the unit.
7.
Deploy from a well dock or other secure location.
8.