In-Situ Level TROLL O-ring Replacement Kit (use this kit for Level TROLL 300/500/700 and Aqua TROLL 100/200 Instruments) User Manual
Level troll maintenance kit
Information Sheet
Due to continuing product development this information is subject to change without notice. Copyright © 2005 by In-Situ Inc. All rights reserved.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Information Sheet
Due to continuing product development this information is subject to change without notice. Copyright © 2005 by In-Situ Inc. All rights reserved.
1 800 446 7488
(toll-free, US and Canada) or 970 498 1500
www.in-situ.com
Level
TROLL
®
Accessories
Level
TROLL
®
Accessories
LEVEL TROLL MAINTENANCE KIT
O-ring. To insure a water-tight seal, replace a worn or damaged o-ring:
•
Remove and discard damaged o-ring
•
Clean o-ring groove on instrument body to remove dirt or residue
•
Lubricate new o-ring sparingly (lubricant included in kit)
•
Install o-ring in groove and remove any excess lubricant
Dust Cap
O-ring. To insure a water-tight seal, replace a worn or damaged o-ring:
•
Remove and discard damaged o-ring
•
Clean o-ring groove on instrument body to remove dirt or residue
•
Lubricate new o-ring sparingly (lubricant included in kit)
•
Install o-ring in groove and remove any excess lubricant
Dust Cap
LEVEL TROLL MAINTENANCE KIT
Use the dust cap to protect the o-ring and connector when
cable is not attached.
Do not allow lubricant to get into the connector.
Use the dust cap to protect the o-ring and connector when
cable is not attached.
Do not allow lubricant to get into the connector.
0052532 07/05
0052532 07/05
Catalog No. 52530
Catalog No. 52530