KANOMAX S388-70 Handheld Particle Counter Data Retrieval Software Manual - Manual (Page 10)

10
3.2 Transferring Data from the Handheld LPC
Data stored in the Handheld LPC can be transferred to the computer by the following procedures.
1) Select the measurement mode of the data to be transferred.
Measurement Modes: REPEAT, SINGLE, CONTINUOUS, CALCULATION, ISO>4
2) Set the instrument Address to match the ID number set for the Handheld LPC.
3) Set the computer Port number.
4) Click the to read in and display the data stored in the Handheld LPC on the Data List
section.
Error Messages:
When having a communication error, the following message will be displayed. (Confirm the instrument
and cable connections.)
When there is no data stored in the Handheld LPC, the following message will be displayed.
5) Input the Start Time and Stop Time.
- Direct input, or
- Click the Sampling Time displayed in the Data List.
6) When the time range of the sampling data is set, click button.
Read in data will be displayed on the Data Table section.
7) By clicking the data number on the Data Table, details of the relevant data will be displayed.