KANOMAX S221-00 Handheld IAQ Monitor - Manual (Page 11)

4-2
4.2. How to Transfer Data
How to transfer the measurement data stored in the IAQ monitor to a computer is described below.
1.
Set the communication setting as instructed previously, and click [Data Transfer] button located at the right
bottom of the main screen.
2. The window similar to the one below will be displayed. Then select the page number and the measurement
mode (Standard or Detailed) of the data needed to be read, and click [Transmit] button.
By clicking [Data Transfer] button on the main screen, the window similar to above will be displayed.
If the measured data has not been stored, a message of “Data is not saved. Does it save?” will be
displayed.
When [Yes] is clicked, a window for data storage will be displayed. Store the data.
In order to transfer data, click [Data Transfer] again.
When [No] is clicked, the Data Transfer window will be opened.
1) Shows the total number of pages stored in the main unit.
2) The number of data stored in the main unit.
3) Sets the page needed to be read. You can also specify it by clicking the cell in the table above.
5) Click to start data transfer
6) Click to close this window. When data is being transferred, the data transfer will be stopped and
the window will be closed.
3. When the window to set the destination of the file to save will be displayed, save it under a new file name.
The file will be saved in CSV format. The default setting for the location where the file is to be saved is
“C:¥”
4) When “CALCULATION” data is being read, the setting value will be effective. When [Standard
Mode] is selected, four data ¡ CO /CO2 / Temperature / Relative Humidity) will be transferred.
When [Detailed Mode] is selected, eight data (CO / CO2 / Temperature / Relative Humidity /
Dew-point Temperature / Wet-bulb Temperature / Absolute Humidity / Humidity Ratio) will be
transferred.
2)
3) 4)
5)
6)
1)