KEPCO DIN KIT KRW (P) - Manual (Page 3)

022504 228-148 4 3
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
4. INSTALL CABLE KIT. Attach wires to the power supply per Instruction Sheet supplied with cable kit.
5. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
mounting clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 4A).
FIGURE 4. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screw-
driver into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage each clip
from the rail. Where mounting clips are close together, it may be necessary to apply leverage with two screwdrivers
simultaneously.
B
REMOVAL INSTALLATION
A