KEPCO DIN KIT MRW 170 (L) - Manual (Page 2)

2 228-1296 061901
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
INSTALLATION
1. INSTALL COVER. Attach the cover to the power supply per Instruction Manual supplied with the cover.
2. INSTALL CLIPS. Attach left and right clips to power supply using hardware supplied (see Figure 2).
FIGURE 2. INSTALLING CLIPS ON POWER SUPPLY
3. INSTALL CABLE KIT. Attach wires to the power supply per Instruction Sheet supplied with cable kit.
4. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 3A).
REMOVING POWER SUPPLY FROM DIN RAIL. With power off, disconnect wires from power supply. While
grasping the power supply with one hand, insert a screwdriver in the area shown in Figure 3B and apply leverage
towards the left as shown in Figure 3B to disengage each clip from the rail. Where mounting clips are close
together, it may be necessary to apply leverage with two screwdrivers simultaneously.
FIGURE 3. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
B
REMOVAL INSTALLATION
A