KEPCO DIN KIT RKW-50 (S) - Manual (Page 2)

2
228-1463 013003
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11352 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com
email: [email protected]
INSTALLATION
1. INSTALL COVER. Attach the cover to the power supply per instruction manual supplied with the cover.
2. INSTALL MOUNTING PLATE. Attach the mounting plate to the power supply using the hardware sup-
plied (see Figure 3).
FIGURE 3. INSTALLING MOUNTING PLATE ON POWER SUPPLY
3. INSTALL CLIPS. Snap the two clips into the mounting plate holes (see Figure 4).
FIGURE 4. INSTALLING CLIPS ON MOUNTING PLATE
4. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 5A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screw-
driver into the access holes provided and apply leverage towards the left as shown in Figure 5B to disengage
each clip from the rail. Where mounting clips are close together, it may be necessary to apply leverage with two
screwdrivers simultaneously.
FIGURE 5. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
L SUFFIX S SUFFIX
S SUFFIX L SUFFIX
B
REMOVAL INSTALLATION
A