KEPCO EL Series USB Driver Manual - Manual

©2010, KEPCO, INC 1
Data subject to change without notice 243-1296 REV 1
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
I N S T R U C T I O N S H E E T
KEPCO
An ISO 9001 Company.
Series EL
SERIES EL USB DRIVER
I — INTRODUCTION
This manual covers the installation and USB driver for the
Kepco Series EL Electronic Loads available at
www.kepcopower.com/support/drivers/drivers-dl3.htm#el
II — DRIVER INSTALLATION.
Follow the steps below to install the EL Load USB Drivers
downloaded from the Kepco website. First download the
EL Load USB driver file kepco_usb_serial_port_drivers.zip
from
www.kepcopower.com/drivers/
Note the location of this zip file in your computer.
1. Create a directory called Kepco USB Drivers at a known
place on your computer (root directory or in My Docu-
ments, etc.).
2. Copy the two driver files (mchpcdc.cat and kepcocdc.inf)
into the Kepco USB Drivers directory.
3. Apply power to the Series EL Electronic Load.
4. Connect the B end of a USB 2.0 cable into the B type
USB port at the rear of the load.
5. Plug the A end of the cable into a USB port on your
computer.
6. The computer responds with the Welcome to the Found
New Hardware Wizard screen.
7. Select the No, Not this Time radio button and click on
Next>.
8. Select Install from a list or specific Location (Advanced)
radio button and click on Next>
.
9. Click on the Search for the best driver in these locations
radio button and check the box Include the location in
the search.