KEPCO Kit 219-0425, Pass Assembly A3 Replacement for ATE 325-0.8 - Manual (Page 2)

2
228-1482 REV 1 052804
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
4. Remove pass assembly A3 from chassis by removing four screws (save screws for reassembly).
5. Install new pass assembly A3 P/N 113-0415 on chassis and secure with four screws previously removed.
FIGURE 1. CHASSIS COMPONENT LOCATION
6. Remove PCB Assembly A1 from chassis by removing four screws (save screws for reassembly), then tag and
remove connectors J201, J202 and J203 from A1 Assembly.
7. On A1 assembly, refer to Figure 2 and install three new parts supplied in Kit (see Table 1).
FIGURE 2. ADDING COMPONENTS TO A1 BOARD