KEPCO KIT 219-0515, BIT 4886 Version 2.0 Firmware Upgrade Kit - Manual

©2006, KEPCO, INC 1
Data subject to change without notice 228-1577 REV 1
I N S T R U C T I O N M A N U A L
KIT
KEPCO
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
An ISO 9001 Company.
219-0515
BIT 4886
FIRMWARE UPGRADE
1. DESCRIPTION
The Kepco KIT Model 219-0515 contains the material to upgrade BIT 4886 Interface Cards, Rev 13 or Rev 14 that
have been previously installed in a BOP power supply to Rev 13A and Rev 14A, respectively, moving to Firmware Ver-
sion 2.0. This instruction sheet provides procedures for installing the components provided.
2. INSTALLATION
2.1 MATERIAL REQUIRED (SEE TABLE 1.)
2.2 UPGRADE PROCEDURE
1. Remove a-c power to BOP by disconnecting line cord.
2. Remove BOP cover (see Section 5, Figure 5-1 of your BOP Instruction Manual).
3. Remove the BIT 4886 Interface card from the BOP as follows (See Figure 2-2 of BIT 4886 Technical Manual):
Step 1. Unplug 3 pin Connector from Transformer from BIT 4886 Card, Location #13.
Step 2. Unplug Cable #2 (5-position connectors) from the BIT 4886 Interface Card, (the other end of the cable with
Location #2 on BOP A1 Assembly.
Step 3. Unplug Cable #1 (18-position connectors) from the BIT 4886 Interface Card, .
Step 4. Remove the lockwashers, and knurled nut securing Connector J204 to hex spacer at location #3, then remove
Connector J204.
Step 5. Remove the knurled nuts and lockwashers securing the BIT 4886 Card to hex spacers and remove BIT 4886
Card.
TABLE 1. MATERIAL REQUIRED
MATERIAL LOCATION QUANTITY
PROM U4, Kepco P/N 250-0663 (replacement) Provided in this Kit 1
Interface Bus Controller U40, Kepco P/N 250-0133 (new) Provided in this Kit 1
Resistpr R75, 2.2K Ohms, 5%, 1/4W, Kepco P/N 115-2382 (new) Provided in this Kit 1
Extractor Provided in this Kit 1
ESD (Electrostatic Discharge) wrist strap. Provided in this Kit 1
Philips Screw Driver Not Supplied N/A