KEPCO KIT 219-0526, ATE-DMG Fast Mode Kit - Manual (Page 2)

2
228-1632 072307
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11355 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
7. Reclose the IC tube. Remove wrist strap and disconnect it from the ATE-DMG chassis.
FIGURE 1. DIGITAL BOARD A7 PROM LOCATION
2.4 ADAPTER ASSEMBLY A11 COMPONENT ADDITIONS PROCEDURE (SEE FIGURE 2)
1. At the rear panel, loosen two screws and disconnect adapter assembly A11.
2. Gain access to A11 components (see Figure 2) by removing two screws securing connector A11J1 to the shell.
3. Connect one end of new capacitor C6 (P/N 117-0999, 1UF, 10%, 50V) to Capacitor C5 closest to pin 12 of U2. Mount ver-
tically, close to J2.
4. Mount one end of new resistor R12 (P/N 115-2174, 10K, 1%, 1/8W) vertically, connecting one end to R6 on leg closest to
J2. Connect other end to free end of C6 which is also mounted vertically.