KROHNE IFC 300 Converter HART 0102 - Manual (Page 15)

Supplementary Installation and Operating Instructions IFC 300 HART
HC275, FC375, AMS, PDM, FDT DTM
Configure
Compare
Clear Offline
-----------------------------------
Status/Conditions
Process Variables
Scan Device
-----------------------------------
Calibration Management
Diagnostics and Test
Calibrate
Reset
-----------------------------------
Rename
Unassign
Assign / Replace
-----------------------------------
Audit Trail
Record Manual Event
Drawings / Notes ...
Help ...
IFC 300 HART Menu Tree AMS
Simulation current output A/C Opt, Cust
Simulation current/frequency output A Opt, Cust
Simulation current/frequency output B Opt, Cust
Simulation frequency output D Opt, Cust
Circuit Board Info
Autom. zero calibration Cust
D/A trim Cust
Apply values Cust
Master Reset
Reset Errors
Reset Configuration Changed Flag
process values:
• volume flow
• mass flow
• flow speed
• conductivity
• coil temperature outputs:
• A
Opt
• % range A Opt
• B Opt
• % range B Opt
• C Opt
• % range C Opt
• D Opt
• % range D Opt
Device:
• tag
Rd
• descriptor Rd
HART:
• Polling Address
Rd
• Device ID Rd
counter:
• counter 1
Opt
• counter 2 Opt
4
1,2,3
Designations:
Opt Optional, dependent on device
implementation / configuration
Rd Read-only
Cust Custody Lock protected
Loc Local AMS, affects only AMS views
KROHNE IFC 300 HA 45e30102 (5/5)
06/05
KROHNE Messtechnik GmbH & Co. KG · Ludwig-Krohne-Str. 5 ‚ D-47058 Duisburg 15/20
Tel.: 0203-301 0 ‚ Fax: 0203-301 389 · e-mail: [email protected]