KROHNE ALTOSONIC V EEx EN User Manual
Page 3
Disclaimer 
 
• This document contains important information on the instrument. KROHNE attempts to
be as accurate and up-to-date as possible but assumes no responsibility for errors or 
omissions. Nor does KROHNE make any commitment to update the information 
contained herein. This manual and all other documents are subject to change without 
prior notice. 
• KROHNE will not be liable for any damage of any kind by using its instrument,
including, but not limited to direct, indirect, incidental, punitive and consequential 
damages. 
• This disclaimer does not apply in case KROHNE has acted on purpose or with gross
negligence. In the event any applicable law does not allow such limitations on implied 
warranties or the exclusion of limitation of certain damages, you may, if such law 
applies to you, not be subject to some or all of the above disclaimer, exclusions or 
limitations. 
• Any instrument purchased from KROHNE is warranted in accordance with the relevant
product documentation and our Terms and Conditions of Sale.
• KROHNE reserves the right to alter the content of its documents, including this
disclaimer in any way, at any time, for any reason, without prior notification, and will not 
be liable in any way for possible consequences of such changes. 
Product liability and warranty 
 
• Responsibility for suitability and intended use of this ultrasonic flowmeter rests solely
with the user. Improper installation and operation of the flowmeter (system) may lead to 
loss of warranty. 
• In addition, the Terms and Conditions of Sale are applicable and are the basis for the
purchase contract.
• If flowmeters need to be returned to KROHNE, please note the information given on the
last pages of the installation and operating instructions. KROHNE regrets that they 
cannot repair or check flowmeter(s) unless accompanied by the completed form (see 
last pages of the installation and operating instructions). 
Items included with order 
 
• UFC-V/EEx (standard or with optional 30 W heater) or UFC-V/LT-EEx (low-
temperature) Ultrasonic Flow Converter
• UFS 500 F/5STR-EEx ultrasonic flow tube, in the size as indicated on the packaging
box.
• Signal
cable
Documentation 
 
These instructions are an extension to the installation instructions and apply to 
ALTOSONIC V UFC-V/EEx and UFC-V/LT-EEx Ultrasonic Flow Converters and the UFS 
500 F/5STR-EEx Flow Sensor. All technical information as described in the installation 
instructions is applicable, when not specifically excluded, completed or replaced by the 
instructions in these additional instructions.