6 set up, 1 general, 2 adjustment elements – KROHNE OPTISWITCH 3300C Transistor EN User Manual
Page 20
6 Set up
6.1 General
The numbers in brackets refer to the following illustrations.
On the electronics module you will find the following indicating
and adjustment elements:
l
Potentiometer for switching point adaptation (1)
l
DIL switch for mode adjustment - min./max. (2)
l
Signal lamp (5)
Note:
As a rule, always set the mode with mode switch (2) before
starting the setup of OPTISWITCH 3300 C. The switching
output will change if you set the mode switch (2) afterwards.
This could possibly trigger other connected instruments or
devices.
6.2 Adjustment elements
3
4
5
1
2
Fig. 14: Oscillator WE60T - Transistor output
1
Potentiometer for switching point adaptation
2
DIL switch for mode adjustment
3
Ground terminal
4
Screwed terminals
5
Control lamp
Function/Configuration
20
OPTISWITCH 3300 C - with transistor output
Set up
29962
-EN
-060830