KYORITSU 2413R - Manual (Page 19)

― 17 ―
５-５ How to Use Data Hold Function
Push in the Data Hold button to freeze the reading. This is especially
useful for taking a reading in a dimly lit or hard-to-reach locations. The
display can be observed away from the conductor. Symbol
“ ” is
displayed on the LCD. Push the button again to release the reading.
５-６ How to use Back Light
When the “Back Light Button”is pressed, the LCD back light will be
on.
It will be automatically off after about 10 seconds.
Note ：Selection with the frequency selector switch dose not apply to
AC output of the two-way analogue output. DC output of the two-
way analogue output reflects the frequency selector switch
setting. Refer to Figure. 1 for frequency characteristics.