KYORITSU 6315 Instruction Manual - Manual (Page 68)

KEW6315 Threshold setting for Power quality (Event)
KEW6315 - 66 -
“Transient”: Over-voltage (Impulse)
Set an instantaneous voltage value as a threshold for the transient event. The following selection range
varies depending on the selected VT ratio.
Selection
±50 to ±2200Vpeak against the nominal voltage (300%)
* Default setting is highlighted in gray.
Move the blue highlight to “Transient”. Show the value entry window.*
Set the voltage value. Confirm. Cancel.
Example of Transient detection:
The details are described in “Displaying recorded events” (P. 116).
Threshold value (voltage value)
Voltage waveform
* A pop-up appears and show the effective range.