Martel Electronics LC100 - Manual (Page 15)

6) When the key is released the %
display will return to normal operation.
C. Min/Max Datalogging
When the LC100 is in any of the measure
modes (mA, mA w/loop power or voltage) it will
continuously monitor and store the minimum
and maximum values for that particular input
mode. To operate the datalogging feature use
the following procedure:
1) Place the LC100 in one of the measure
modes.
2) Connect the LC100 to the unit under test.
3) Clear the min/max memory by pressing both
keys (min and max) simultaneously. The
LCD will display “CLR” when the memory is
cleared.
4) Allow the unit to log min. and max. for as
long as required.
Warning: You may want to disable the Battery
Save feature before using the Dataloggiong
Mode to prevent the LC100 from turning off pre-
maturely.
5) At any time press the min. or max. to display
the value stored.
6) Turning off the LC100 or changing modes
will clear the memory. Be sure to record
your data before turning off the unit.
%ERROR
13